Spray’N’Seal™ is a breathable, premium, natural look sealer to provide maximum stain resistance to stone, tile, mosaics, grout & other porous surfaces. It is non-yellowing, non-coating and UV resistant. Can be used on newly installed grout 2 hours after grouting however for best performance allow grout to fully cure before sealing. Utilises the latest Nano-AQS™ & Rapid-Seal C6 FluoroTM Technology to provide good stain resistance after only 4 hours. Can also be used as a pre-grouting sealer. Allows excellent Moisture Vapour Transmission (MVT). For interior & exterior. USE: For Porous Stone, Tile, Grout, Glass, Mosaics, Canvas, Wood etc.

Due to the nature of different surfaces, you should do a few inconspicuous test areas following label instructions to determine ease of application, surface colour stability and the desired results. The end user must determine the suitability of the product for their intended use.

1. Sweep, vacuum or wipe surface clean;
2. Shake can well before using;
3. Apply product directly to clean, dry surface from approximately 20-30cm and spray in an even, slow sweeping motion;
4. If only sealing grout joints minimize spray on the surrounding areas;
5. If severe over-spray occurs, wipe the surface DRY with absorbent paper or cotton towels after 5-10 minutes, to remove any excess sealer;
6. If 2 or more coats are required, allow minimum 30 minutes between coats and follow label instructions for each coat;
7. The surface is ready for light traffic after 2 hours;
8. Keep surface dry for minimum 24 hours.

http://www.sealersplus.com.au/our-products/spray-n-seal/

http://www.youtube.com/watch?v=yd-OTqlxsfc